tag:blogger.com,1999:blog-7532990877498512287.post848332736108356822..comments2024-02-26T20:09:45.487-08:00Comments on Sam Russell Central: Brocade and Juniper Interop - OSPF, MPLS, VLL/VPLS, and VRF interconnectsSam Russellhttp://www.blogger.com/profile/03431137767320819102noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-7532990877498512287.post-82045013859632648152020-12-22T02:38:19.070-08:002020-12-22T02:38:19.070-08:00thank you for the article! old but still up to dat...thank you for the article! old but still up to date :)Evgenyhttps://www.blogger.com/profile/07905720350519191948noreply@blogger.comtag:blogger.com,1999:blog-7532990877498512287.post-1727446630137203872020-11-27T03:58:06.298-08:002020-11-27T03:58:06.298-08:00Hey, I know this is 3 years late, just wanted to s...Hey, I know this is 3 years late, just wanted to say thanks for the comment and I'm glad you found it useful!Sam Russellhttps://www.blogger.com/profile/03431137767320819102noreply@blogger.comtag:blogger.com,1999:blog-7532990877498512287.post-74219543028364667832018-03-15T17:28:25.511-07:002018-03-15T17:28:25.511-07:00Very useful. thx. Im a JunOS head, and have inheri...Very useful. thx. Im a JunOS head, and have inherited a Brocade CER Network. Ive done VLL <> L2CKT already and it works fine. Cool cheat chest above for BFD over OSPF and such. Thanks!Juniperdudehttps://www.blogger.com/profile/10012754719518812494noreply@blogger.comtag:blogger.com,1999:blog-7532990877498512287.post-54902147741057307552013-10-09T08:33:52.375-07:002013-10-09T08:33:52.375-07:00Thanks for the info! The info was right what I nee...Thanks for the info! The info was right what I needed to make the VPLS between our Brocade and Juniper, but I seem to do something wrong. This because the tunnel is up and I see MAC addresses from both sides, but that's it. I can't ping trough the tunnel for example.<br /><br />I think this is because of what you already describe regarding "vlan-id none" and that is that the Juniper is tagging the traffic. But I'm not able to use the command, in the routing-instance.<br /><br />Do you happen to know what I'm doing wrong? I'm using a old trusty M7i with Junos 12.1.<br /><br />Thanks!<br /><br />JustinAnonymoushttps://www.blogger.com/profile/03474982477264769333noreply@blogger.com